I was playing around with my Arduino Uno R3 board with Sublime Text 2 & 'Stino' as IDE
I am not sure if it is my code is the problem or if I broke something...
I pressed upload while another sketch didn't finish uploading, even the original Arduino IDE can't upload new sketches anymore!

This is my code:

// singleServo.ino

#include <Servo.h>

Servo servo;
const int button = 2;
const int led = 13;
const int buzzerPin = 10;
const int duration = 180;

int stateLED = LOW;
int previous = LOW;

void setup() {
    pinMode(led, OUTPUT);
    pinMode(button, INPUT);
    pinMode(buzzerPin, OUTPUT);
    Serial.begin(9600);
}

void loop() {
    int stateButton;

    stateButton = digitalRead(button);

    if (stateButton == LOW && previous == LOW) {
        if (stateLED == HIGH) 
        { 
            stateLED = LOW; 
            initAction(duration);
        }
        else 
        { 
            stateLED = HIGH;
        }
    }
    
    digitalWrite(led, stateLED);
    previous = stateButton;
    servo.detach();
}

void initAction(int time_iA){
    tone(buzzerPin, 523, 200);
    delay(200);
    
    shiftServo(180, time_iA);

    tone(buzzerPin, 262, 200);
}

void shiftServo(int angle, int time_sS) {
    servo.attach(9);
    delay(500);
    int position;
    
    for(position=0; position <= angle; position += 1)
    {
        servo.write(position);
        delay(time_sS / 180);
        Serial.println(servo.read());
    }
    // for(position=angle; position >= 0; position -= 1)
    // {
    //  servo.write(position);
    //  delay(time_sS / 90);
    // }
}

I am a newbie with all things Arduino - Please help!

EDIT: After rebooting the system (Ubuntu Linux 14.04) everything was working just fine again!
But I'm going to take the serial functions out too.