Questions tagged [openwrt]
Linux distribution primarily targeted at routing on embedded devices.
574 questions
0
votes
0
answers
22
views
Getting disconnects cause of dnsmasq
I have some Problems during playing on my Playstation5. I´m using a router with open wrt VPN and so on.
Each hour +- i get disconnected...
I put a screenshot of the System Log maybe someone has an ...
Dustin Baldewein
-1
votes
1
answer
197
views
I cannot into VLANs, I can’t get them to work, please assume I not know how to computer nor network, as I'm burnt out
I have read guides on this topic and I don't know what is and isn't correct (also for my setup). So please assume I could have made a simple mistake somewhere.
Goal:
have VLANs to separate some ...
0
votes
1
answer
138
views
OpenWRT: main/iot VLANs with transparency and security
I have two VLANs in my home network:
iot (for anything i consider an IoT device)
main (for everything
else)
I am using OpenWRT.
Each VLAN has its own subnet.
iot: 192.168.1.0/24
main: 192.168.0.0/...
- 111
0
votes
0
answers
45
views
MT6000 OpenWrt Routing Deadlock: Simultaneous WireGuard Server/Client & AdGuard Home
1. Hardware & Environment
Device: GL.iNet MT6000 (Flint 2).
Firmware: stable 24.10
Setup: Dual WireGuard tunnels + AdGuard Home + PBR (Policy Based Routing).
2. The Goal
I am trying to achieve ...
0
votes
1
answer
139
views
Why does the WireGuard tunnel connect on all devices, but works only on latest in the list?
I have 3 devices connecting over wan interface to wg0 WireGuard VPN interface. Relevant internal interfaces are LAN IPv4: 192.168.5.1/24 and wg0 IPv4: 10.14.0.1/24. It used to work for 'macOS Device 1'...
- 3
1
vote
0
answers
102
views
Why is it that after running certbot, I get connection refused on my Nginx server and I can't see why?
Putting mydomain.me into Firefox/Vivaldi fails to connect, with this:
GET https://mydomain.me/ NS ERROR CONNECTION REFUSED
Firefox is set up to convert http to HTTPS (but I've tried to turn ...
- 155
0
votes
0
answers
213
views
Want to setup VLAN for IOT using OpenWrt v21.02 and LuCI 22.03
I am using a Gl.inet AX-1800 router using the LuCI through the link provided in the advanced settings page.
I want to create a simple IOT vlan. I know I could use "guest" to do this, which ...
- 101
0
votes
0
answers
49
views
Diagnostic fails when I try to make my archer c20 router a repeater
My router is a TP-Link Archer c20 v4. I installed openwrt to setup a repeater and used the link to set it up.
I followed each step but when I run diagnostics it says ping: bad address 'openwrt.org'
I ...
- 133
0
votes
0
answers
77
views
Can not build OpenWRT 24.10 with ffmpeg-custom cause of lack of libavformat.so and libswresample.so
Here is an error description:
cp: can not stat '/home/ladmin/openwrt/build_dir/target-x86_64_musl/ffmpeg-audio-dec_6.1.2/ipkg-install/usr/lib/libavfilter.so.*': No such file or directory
cp: can not ...
- 11
0
votes
0
answers
102
views
How can I configure my router to enable network discovery in my apartment?
My current predicament is that my apartment's Wi-Fi/Network is set up so that all network sharing and discovery is disabled (for obvious reasons) but that has made me unable to access my NAS as well ...
1
vote
0
answers
246
views
Access internal hosts from Wireguard VPN
I have the following setup:
I configured Wireguard connation between Wireguard server and OpenWRT router as a client. Internal machines can use Internet only via the VPN connection. I created routing ...
- 199
0
votes
0
answers
218
views
How do I properly compile FFmpeg for OpenWRT 23.05 with support of H.263, H.264 and H.265 decoding video stream from an IP camera?
I have a Tiandy IP-camera which can only output videostream encoded with H.263, H.264 or H.265 codec. I want to use motion package to process video stream for surveillance.
Unfortunately (because of ...
- 11
0
votes
0
answers
146
views
How to route traffic from specific interface via netns on OpenWRT?
I have an OpenWRT router that is used as a VPN server (WireGuard). I need to isolate a certain transparent proxy and other programs (traffic shapers and analysers) in a namespace so that they don't ...
- 101
1
vote
0
answers
458
views
How can I route traffic from a wireguard interface to a specific interface in OpenWRT?
I have an ASUS router with OpenWRT 22.03 at home. It has internet on the wan port, a br-lan that shares the local eth0.1 and wlan0-1 on a virtual bridge and a network named cam that is also a wireless ...
- 11
0
votes
0
answers
125
views
Is it possible to install Debian 12 on a TP-Link ER605 v2 router?
I already have a bare OpenWRT installed on my TP-Link router. Is it possible to install Debian 12 on it? I would like a cleaner Linux distribution without any pre-installed networking software
- 103