Skip to main content

Questions tagged [plumbing]

For questions about the supply and removal of water and liquid waste.

0 votes
0 answers
5 views

My house has a hot water storage tank which is heated by water circulating through a loop that passes through a heat exchanger in another room, near the boiler. This tank is used to supply water to ...
WillO's user avatar
  • 283
0 votes
1 answer
15 views

I have multiple sinks where we have the same situation. The wall tube is glued into a stub. The stub has about 1/2 inch sticking out so I cannot start over. The wall tube is 1 1/2", the old ...
DMoore's user avatar
  • 50.8k
2 votes
1 answer
86 views

I discovered a "fun" spigot leak over the weekend and wanted to check with the hivemind before repairing. The copper feeding the outdoor spigot appears to have burst. It sprays water when ...
Ezra's user avatar
  • 23
0 votes
1 answer
51 views

I have an Aprilaire 800z steam humidifier. The steam hose keeps slipping off after only a few weeks of operation. The unit was installed 2 years ago. The problem has occurred every winter, but it's ...
bpaterni's user avatar
  • 101
0 votes
2 answers
272 views

I a visiting a relatives home and would like to know where the main water shutoff valve is located. Is there a systematic process, starting from the inside of the house to locate the main water valve? ...
gatorback's user avatar
  • 3,298
0 votes
1 answer
69 views

I have a Weil-McLain CGa-6 cast iron boiler. It is not connected to my system yet and I just did a pressure test on it. It passed. I likely won't install it until maybe June or July, so I'm ...
user3080392's user avatar
0 votes
4 answers
67 views

The handle on the sillcock just spins so the water won’t turn off. It has a frost proof stem and I don’t have access to it on the interior of the house. It has been a slow leak for a while so I’m ...
junta's user avatar
  • 1,133
0 votes
0 answers
67 views

I have this blocking board that is installed there so I can screw the support for the shower column into it Just below that point at the base of the shower base I will have the stub outs, like below. ...
MiniMe's user avatar
  • 3,875
1 vote
0 answers
48 views

I have a half bath on first floor (7' x 9') and full bath on second floor (7' x 12'). I am looking for options for locating the main stack and vents. A side inlet tee to connect the shower and ...
renovt's user avatar
  • 11
5 votes
1 answer
612 views

I managed to remove the screw from the handle, but I still can't detach the handle itself to replace the cartridge. I tried using WD-40, tapping around the handle, and pulling straight up, but none of ...
john chang's user avatar
3 votes
1 answer
110 views

I have had my house repiped with pex and have been frustrated with the noise that comes with how it reacts to heat. I have a boiler and hot water heating, so the temperature difference can be quite ...
user2374537's user avatar
0 votes
0 answers
38 views

I have a B&G Monoflo hydronic heating system in my house that was installed in the early 1950s. I have cast iron radiators throughout the house. There are two circuits, but only one thermostat, ...
user3080392's user avatar
0 votes
1 answer
86 views

Can the flow restrictor always be removed on a showerhead? The following showerhead is stumping me as the green flow restrictor seems to be wider than the opening. Any suggestions on how to get it out?...
Wynne's user avatar
  • 1,775
1 vote
1 answer
105 views

I'm interested in adding hot water recirculation to my house. I believe that all of the plumbing meant to facilitate it is already in place, but I'm not sure I fully understand it. What is the intent ...
nlawalker's user avatar
  • 153
0 votes
2 answers
49 views

I wanted to add some caulk between the sink counter and sink. (green area). Should I use Adhesive Caulk, or Silicone caulk ? The old caulk is rubbing off, and want to apply new one. Also, is it okay ...
mattsmith5's user avatar

15 30 50 per page
1
2 3 4 5
525